Oster CKSTDFFM40 User Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
English-4 English-5
PARTS IDENTIFICATION
Before using your Deep Fryer for the first time, you should become familiar
with all of the parts. Read all Instructions and Safeguards carefully.
USING YOUR OSTER DEEP FRYER
NOTE: Never plug in fryer with an empty Oil Reservoir. Always use your fryer on
a flat, heat resistant surface.
Attach magnetic end of Sure Release power cord
assembly directly to the fryer. This should be done
prior to plugging the cord into the wall outlet. The
magnetic end of the cord is designed only to go on
one way. Be sure the side stating “THIS SIDE UP”
is facing up. (See Figure 1)
Open Lid by pressing the Lid Button.
Remove Frying Basket.
Pour cooking oil into Oil Reservoir until it reaches
between “MIN” and “MAX” marks inside reservoir.
DO NOT OVER OR UNDER FILL. Place the
Frying Basket back into Fryer in the upper position
by hooking over oil reservoir. (See Figure 2)
Close Lid.
Insert plug into 120 volt AC outlet.
The power light will come on and the Fryer will
begin heating.
Turn the fryer to desired temperature position.
For best results, wait 20 minutes for the oil to reach cooking temperature.
Open Lid by pressing the Lid Button.
CAUTION: Escaping steam is hot! Be careful when opening lid.
With the Frying Basket in the upper position, place food inside Frying Basket
(Do not over stack food). Close Lid. Lower the basket into oil by lifting it up
off hook and setting down into the oil.
CAUTION: Always replace and close Lid before immersing food in oil. Do not
immerse or drain food with Lid removed or open. Disconnect Plug from wall.
WARNING: DO NOT USE SURE RELEASE POWER CORD SYSTEM TO
DISCONNECT THE FRYER. ALWAYS DISCONNECT PLUG FROM WALL
OUTLET FIRST TO DISCONNECT FRYER.
Use only Model #PL1215 magnetic cord set with this product. The use of any other
magnetic cord set may cause fire, electric shock, or injury.
CAUTION: The Sure Release Power Cord is only for accidental disconnection and
is not to be removed during normal operation. If the cord becomes disconnected, the
user should immediately unplug the cord set from the wall outlet, then reconnect.
(See Figure 1)
T
H
I
S
S
I
D
E
U
P
Figure 1
R
ai
s
e
Lo
w
e
r
H
oo
k
Figure 2
Lid Button
Main Housing
Power Indicator
Sure Release Power Cord
(not shown)
Handle
Lid Filter Cover
Slide Switch
Page view 2
1 2 3 4 5 6 7 8 ... 11 12

Comments to this Manuals

No comments